Interface soil moisture sensor and water pump with NodeMCU


  • Interface soil moisture sensor and mini water pump with NodeMCU


  1. NodeMCU board (quantity: 1 no.)
  2. Micro USB cable A to B (quantity: 1 no.)
  3. Breadboard (quantity: 1 no.)
  4. 12V mini water pump (quantity: 1 no.)
  5. Soil moisture sensor (quantity: 1 no.)
  6. Jumper wire – male to male (quantity: 6 no.)
  7. Jumper wire – male to female (quantity: 4 no.)
  8. Arduino IDE on your computer

Let’s begin!


Interfacing soil moisture sensor and mini water pump module with NodeMCU


Final Code

To copy the code, right click on view raw at the bottom of the code, click on open link in new tab and then copy the code.

There you go!


Loader Loading...
EAD Logo Taking too long?
Reload Reload document
| Open Open in new tab
April 22, 2020

18 responses on "Interface soil moisture sensor and water pump with NodeMCU"

  1. Where to buy steroids | Where to buy real steroids online forum? https://wheretobuysteroids2022.wordpress.com

  2. Delta Airlines Phone Number | Delta airlines customer service phone number https://sites.google.com/view/delta-airlines-phone/

  3. Delta Air lines Colorado Springs. Arizona booking customer service customer service phone number https://delta-airlines-2022.blogspot.com

  4. Веном 2 – смотреть онлайн в хорошем качестве https://bit.ly/venom2-2021

Leave a Message

Your email address will not be published.


Knowledge and Content by Li2 Technologies | © 2021 NASSCOM Foundation | All rights reserved